Installation and use of led ceiling lights
2022-11-08
As the heat of home decoration continues to heat up, the change of ceiling lamps is also changing with each passing day. It is no longer limited to the previous single lamp, but is developing towards diversification. It not only absorbs the luxury and style of the chandelier, but also adopts the ceiling-mounted installation method. It avoids the defect that large luxury lighting cannot be installed in shorter rooms. The lamp body of the ceiling lamp is directly installed on the roof and is suitable for overall lighting, usually used in living rooms and bedrooms. The following points should be paid attention to when installing and using ceiling lamps: 1. When installing ceiling lights in masonry structures, pre-embedded bolts should be used, or expansion bolts, nylon plugs or plastic plugs should be used to fix them; wooden wedges should not be used. And the bearing capacity of the above-mentioned fixing parts should match the weight of the ceiling lamp. In order to ensure that the ceiling lamp is fixed firmly and reliably, and its service life can be extended. 2. When using expansion bolts for fixing, the specifications of the bolts should be selected according to the technical requirements of the product, and the drilled hole diameter and embedded depth should be consistent with the specifications of the bolts.
3. The number of fixed lamp socket bolts should not be less than the number of fixed holes on the base of the lamp, and the diameter of the bolt should match the aperture; lamps without fixed installation holes on the base (drill holes during installation), each lamp is used for fixing The number of bolts or screws should not be less than 2, and the center of gravity of the lamp should be consistent with the center of gravity of the bolts or screws; only when the diameter of the insulation table is 75mm or less, one bolt or screw can be used for fixing. 4. Ceiling lamps cannot be directly installed on flammable objects. Some families use painted three plywood behind the ceiling lamps for aesthetics. In fact, this is very dangerous, and heat insulation measures must be taken; if the high temperature part of the lamp surface is close to flammable objects Insulation or heat dissipation measures should also be taken. 5. Before installing the ceiling lamp, it should also be checked: ① The cross-section of the wire core leading to each lamp, the copper core flexible wire is not less than 0.4mm2, and the copper core is not less than 0.5mm2, otherwise the lead must be replaced. ②The connection between the wire and the lamp holder and the connection of the parallel wire between the lamp holders should be firm, and the electrical contact should be good, so as to avoid the danger of sparks between the wire and the terminal due to poor contact. 6. If the screw cap is used in the ceiling lamp, the following two points should be paid attention to in its wiring: ① the phase wire should be connected to the terminal of the center contact, and the neutral wire should be connected to the screw terminal; ② the insulation of the lamp cap There should be no damage and leakage of the casing to prevent electric shock when replacing the Bulb. 7. For ceiling lamps equipped with incandescent bulbs, the bulbs should not be close to the lampshade; the power of the bulbs should also be selected according to the technical requirements of the product, and should not be too large, so as to avoid the temperature of the bulbs being too high and the glass cover breaking and falling down and hurting people. 8. The two wires connected to the power inlet of the ceiling lamp should have good electrical contact, and they should be wrapped with black tape and kept at a certain distance. If possible, try not to put the two wires under the same piece of metal. In order to avoid short circuit and danger. 9. Teach children not to throw balloons and other objects at the lamps indoors, so as to avoid the decorations hanging on the lamps falling and hurting people or affecting the decorative effect of the lamps. Here you can find the related products in led module lights.LED Spot Light.LED Bulb.LED Down Light.LED Step Light, we are professional manufacturer of LED Ceiling Light Module. For more details about the product, please contact us: Tel:86-750-3722999 Fax:86-750-3726999 Mobile Phone:+8613827021234 Email:info@jmyideng.com
